| 1 |
4.0 LITER W/E-HYBRID.
|
PAB121251B
View Product
|
$729.35
|
|
|
|
|
| 2 |
Left.4.0 LITER W/E-HYBRID. Right.4.0 LITER W/E-HYBRID. Upper insulator.
|
95810665100
View Product
|
$7.21
|
|
|
|
|
| 3 |
Left.4.0 LITER W/E-HYBRID. Right.4.0 LITER W/E-HYBRID.
|
95810666500
View Product
|
$10.02
|
|
|
|
|
| 4 |
Left.4.0 LITER W/E-HYBRID. Right.4.0 LITER W/E-HYBRID. Upper insulator retainer clip.
|
95812109500
View Product
|
$3.04
|
|
|
|
|
| 5 |
4.0 LITER W/E-HYBRID. A Sensor used to measure the Temperature of the battery pack, used to determine if the Cooling system is working properly. Location-Coolant Hose. Location-Engine Block. Location-Engine Coolant Hose. Location-Engine Cylinder Head. Location-Radiator Coolant Hose. Temperature Sensor for Engine Coolant. Sending Unit. Cylinder Head. Drive Motor Battery Pack. Engine. Included with: Battery, Heat exchanger, Hose & tube assembly, Radiator.
|
95860662320
View Product
|
$137.17
|
|
|
|
|
| 6 |
4.0 LITER W/E-HYBRID. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spRing that prevents fluid from leaking at the Engine Coolant Temperature Sensor. A round Ring used to Seal between the EGR Valve Temperature Sensor and it's mounting surface. A round Ring used to Seal between the Radiator Hose and it's mounting surface. An o-Ring used to prevent a leak at the Drive Motor Battery Pack Coolant Hose. Engine Coolant Temperature Sensor O-Ring. Location-Coolant Hose. Location-Cylinder Head. Location-Engine. Location-Engine Block. Location-Engine Cylinder Head. Part cannot be reused/reinstalled. switch o -. Drive Motor Battery Pack Hose O -. Engine O -. Exhaust Gas Recirculation (EGR) Valve O -. Hose AND tube Assembly o -. Radiator Hose O -. Water pipe o -. Included with: Cooler Assembly, EGR Cooler, Heat exchanger, Hose & tube Assembly, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Radiator, Temp Sensor, Temperature Sensor, Temperture Sensor.
|
WHT002287B
View Product
|
$1.64
|
|
|
|
|
| 6 |
4.0 LITER W/E-HYBRID. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spRing that prevents fluid from leaking at the Engine Coolant Temperature Sensor. A round Ring used to Seal between the EGR Valve Temperature Sensor and it's mounting surface. A round Ring used to Seal between the Radiator Hose and it's mounting surface. An o-Ring used to prevent a leak at the Drive Motor Battery Pack Coolant Hose. Engine Coolant Temperature Sensor O-Ring. Location-Coolant Hose. Location-Cylinder Head. Location-Engine. Location-Engine Block. Location-Engine Cylinder Head. Part cannot be reused/reinstalled. switch o -. Drive Motor Battery Pack Hose O -. Engine O -. Exhaust Gas Recirculation (EGR) Valve O -. Hose AND tube Assembly o -. Radiator Hose O -. Water pipe o -. Included with: Cooler Assembly, EGR Cooler, Heat exchanger, Hose & tube Assembly, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Radiator, Temp Sensor, Temperature Sensor, Temperture Sensor.
|
WHT002287B
View Product
|
$1.64
|
|
|
|
|
| 7 |
4.0 LITER W/E-HYBRID. Temp sensor screw. A Screw that is used to secure the Hood Latch Support to its mounting point. A Screw that is used to secure the Hood Release Cable to it's mounting point. A Screw that is used to secure the Intake Air Temperature Sensor to its mounting point. A Screw that is used to secure the Radiator Support Baffle to it's mounting point. A Screw that is used to secure the Radiator Support Panel to it's mounting point. A Screw that is used to secure the Radio Amplifier to it's mounting point. A Screw that is used to secure the Trunk Floor Storage Box to its mounting point. A Screw used to secure the Drive Belt Cover to its mounting surface. A Screw used to secure the Seat Lumbar Adjustment Handle to its mounting surface. A Screw used to secure the Steering Knuckle to its mounting surface. A Screw used to secure the turbo boost Sensor to its mounting surface. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Engine Coolant Temperature Sensor to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Hood Release Handle to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Hybrid Battery Compartment to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Turbocharger Boost Sensor to it's mounting point. Bolt for the brackets that hold the Radiator Hose. Bumper Cover Reinforcement Screw. Bumper Cover Support Rail Screw. Engine Air Intake Hose Bolt. Engine Air Intake Hose Screw. Engine Coolant Pipe Bolt. Engine Coolant Reservoir Bolt. Mounting Bolt. Secures the active suspension control module to it's mounting point in the vehicle. Included with: Lower Hose, Lower Hose Part cannot be reused/reinstalled, Radiator, Reservoir cap.
|
N10721401
View Product
|
$0.61
|
|
|
|
|
| 7 |
4.0 LITER W/E-HYBRID. Temp sensor screw. A Screw that is used to secure the Hood Latch Support to its mounting point. A Screw that is used to secure the Hood Release Cable to it's mounting point. A Screw that is used to secure the Intake Air Temperature Sensor to its mounting point. A Screw that is used to secure the Radiator Support Baffle to it's mounting point. A Screw that is used to secure the Radiator Support Panel to it's mounting point. A Screw that is used to secure the Radio Amplifier to it's mounting point. A Screw that is used to secure the Trunk Floor Storage Box to its mounting point. A Screw used to secure the Drive Belt Cover to its mounting surface. A Screw used to secure the Seat Lumbar Adjustment Handle to its mounting surface. A Screw used to secure the Steering Knuckle to its mounting surface. A Screw used to secure the turbo boost Sensor to its mounting surface. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Engine Coolant Temperature Sensor to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Hood Release Handle to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Hybrid Battery Compartment to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Turbocharger Boost Sensor to it's mounting point. Bolt for the brackets that hold the Radiator Hose. Bumper Cover Reinforcement Screw. Bumper Cover Support Rail Screw. Engine Air Intake Hose Bolt. Engine Air Intake Hose Screw. Engine Coolant Pipe Bolt. Engine Coolant Reservoir Bolt. Mounting Bolt. Secures the active suspension control module to it's mounting point in the vehicle. Included with: Lower Hose, Lower Hose Part cannot be reused/reinstalled, Radiator, Reservoir cap.
|
N10721401
View Product
|
$0.61
|
|
|
|
|
| 8 |
Left.4.0 LITER W/E-HYBRID. Lower insulator. Right.4.0 LITER W/E-HYBRID.
|
95812127510
View Product
|
$10.41
|
|
|
|
|
| 9 |
Left.4.0 LITER W/E-HYBRID. Lower insulator buffer. Right.4.0 LITER W/E-HYBRID. A rubber ring with a hole in the center which provides protection through which Radiator related components pass through. Primary. Radiator Insulator. Auxiliary mount. Bracket. Bushing. Frame isolator. Grommet. Heater core. RUBBER Buffer. Support.
|
95812126810
View Product
|
$14.10
|
|
|
|
|
| 10 |
Left.4.0 LITER W/E-HYBRID. Lower insulator mount bolt. Right.4.0 LITER W/E-HYBRID.
|
95880539920
View Product
|
$3.94
|
|
|
|
|
| 11 |
4.0 LITER W/E-HYBRID. Drain plug.
|
9A713333500
View Product
|
$21.94
|
|
|
|
|
| 12 |
4.0 LITER W/E-HYBRID. Reservoir.
|
PAB121407A
View Product
|
$80.29
|
|
|
|
|
| 13 |
4.0 LITER W/E-HYBRID. Reservoir bracket.
|
PAB121412A
View Product
|
$84.39
|
|
|
|
|
| 14 |
4.0 LITER W/E-HYBRID. Reservoir grommet.
|
PAB12158500
View Product
|
$3.93
|
|
|
|
|
| 15 |
4.0 LITER W/E-HYBRID. Reservoir bolt. A Bolt used to attach the Drive Motor Battery Pack Control Module to its mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc) on one end used to secure the HVAC Electronic Control Module to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc) on one end used to secure the Supercharger Intercooler to it's mounting point. Air Filter Housing Bolt. Battery Tray Bolt. Bumper Guide Bolt. Engine Coolant Reservoir Bolt. Engine Water Pump Bolt. Air Filter Housing. Battery Tray. Bumper Guide. Charge Air Cooler. Cover retainer screw. Drive Motor Battery Pack Control Module. Engine Coolant Reservoir. Engine Water Pump. HEXAGON - HEAD SCREW 6. HVAC Control Module. Intercooler. Mount bracket. Included with: Cover.
|
N10785701
View Product
|
$0.68
|
|
|
|
|
| 15 |
4.0 LITER W/E-HYBRID. Reservoir bolt. A Bolt used to attach the Drive Motor Battery Pack Control Module to its mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc) on one end used to secure the HVAC Electronic Control Module to it's mounting point. A threaded rod with a Drive head (such as hex, 12 point, torx, etc) on one end used to secure the Supercharger Intercooler to it's mounting point. Air Filter Housing Bolt. Battery Tray Bolt. Bumper Guide Bolt. Engine Coolant Reservoir Bolt. Engine Water Pump Bolt. Air Filter Housing. Battery Tray. Bumper Guide. Charge Air Cooler. Cover retainer screw. Drive Motor Battery Pack Control Module. Engine Coolant Reservoir. Engine Water Pump. HEXAGON - HEAD SCREW 6. HVAC Control Module. Intercooler. Mount bracket. Included with: Cover.
|
N10785701
View Product
|
$0.68
|
|
|
|
|
| 16 |
4.0 LITER W/E-HYBRID. Reservoir nut. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Door Shell. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Engine Coolant Expansion Tank. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the HVAC Case. Bracket. Door Shell cap. Engine Coolant Reservoir. HVAC Unit Case. Rail REINFORCED. Rivetted cap.
|
PAF106185
View Product
|
$2.30
|
|
|
|
|
| 17 |
4.0 LITER W/E-HYBRID.
|
PAB121321A
View Product
|
$36.09
|
|
|
|
|
| 18 |
4.0 LITER W/E-HYBRID. Reservoir cap gasket.
|
PAB121809
View Product
|
$8.32
|
|
|
|
|
| 19 |
4.0 LITER W/E-HYBRID.
|
PAB145804
View Product
|
$692.33
|
|
|
|
|